Alrighty,I (almost) made a Jolly Roger tank,but I do not know where to go from here,maybe I can get advice from good skinners?

Oh,and if somebody has made a Jolly Roger skin before...Bite me. :)

Perhaps a shot with the skin on the tank would be helpful too.

Here ya go,

.
.
.

.
.
.

There,that good enough?

I'd do an iron cannon on a wooden pivot

I'm trying to stay on the Jolly Roger theme,not pirate.

Color me confused, but the Jolly Roger was the flag of a Pirate Ship... %)

Ahh, I can picture this.

Try and make the remaining green colored black(Dont fill it with black, just use a filter that takes the green away and replaces it with black.)
and put a skull on each side of the turret holder.

You guys are not getting it!

The Jolly Roger is the FLAG,I want this skin based only off the FLAG.

*shrug* Whatever. Put finger bones on the gun barrels, arm and hand bones on the turret, and upper arm bones on the sides, so that the upper arm goes up, the elbow happens at the joint, the lower arm reaches out toward the muzzles, the hand is at the edge, and the fingers are the barrels.

Lol

What TMO said...and I'd add some contrast between the tanks parts. Perhaps you could use varying shades of black so you can distinguish one part of the tank from another. If you're really clever, add some fabric folders too.

^what Rabban said.
make it LOOK like a flag, i.e., tatters, rips, tears, folds, ripples, etc.

How do u get a skin for urself? I dont get it can someone tell me more about skins I dont really even no wat they r

Last edited: Tuesday, January 18, 2005 at 5:20:07 PM